Fronius Acctiva Professional Flash User Manual download pdf (Page 56)

User charging

mode

User charging is an additional charging mode in which charging parameters for the device

can be specified individually.

The parameters for user charging mode are preset in the factory for standby applications

(e.g. emergency power systems) or for ambient temperatures > 35° C (95° F).

The user charging mode should be used for:

- charging / conservation charging with battery either fitted or removed

- trickle mode (to charge the battery when consumers in the vehicle are switched on)

External power

supply mode

The external power supply mode is to ensure consumers have a power supply

- when there is increased power consumption (e.g. updating firmware/software for the

vehicle’s electronics),

- in back-up mode, to supply power to the on-board electronic systems while the battery

is being changed (to avoid losing settings such as time, radio settings, etc.).

Charge accept-

ance test mode

Charge acceptance test mode is used to test a battery’s ability to accept a charge. The test

takes place as follows:

- the automatic charge acceptance test takes only a few minutes

- the charge acceptance test is ended after a predefined period has elapsed

- if the result is positive, the device will switch automatically to standard charging mode

and charge the battery

- if the result is negative, „Test Fail“ appears on the charger’s screen and charging of

the battery is halted.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 159 160

No comments

Fronius Acctiva Professional Flash User Manual Page 56