Fronius Symo 10-20 kW User Manual download pdf (Page 10)

Installation notes

Selecting dowels

and screws

IMPORTANT! Depending on the surface, different dowels and screws may be required for

installing the wall bracket. Therefore, these dowels and screws are not part of the scope of

supply for the inverter. The system installer is responsible for selecting the proper dowels

and screws.

Recommended

screws

To install the inverter, the manufacturer recommends the use of steel or aluminium screws

with a diameter of 6 - 8 mm.

Fitting the wall

bracket

Installing the in-

verter on a mast

When installing the inverter on a mast or support, Fronius recommends the “Pole clamp”

mast fixing set from Rittal GmbH (order no. SZ 2584.000).

This set enables the inverter to be installed on round or rectangular masts with the follow-

ing diameters: ∅ between 40 and 190 mm,  between 50 and 150 mm

NOTE! When fitting the wall bracket to the wall or a pillar, ensure that the wall

bracket does not become warped or deformed.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Fronius Symo 10-20 kW User Manual Page 10